...data in a single cable. HDMI is the de facto standard for consumer electronics. HDMI is backward compatible with DVI. Buy only tested cables with the HDMI logo. This guarantees the cable will perform to specification especially because there ...

...mount shelves, trays, cable managers, and power strips. • Shelves • Shelves are an easy solution for storing things that aren’t rackmountable. The shelves attach to the rails; servers or other equipment sits on the shelves. Make sure the shelf has...

...connecting IEEE-488 cables, some rules apply. The total number of devices should be 15 or less. The total length of all cables should not exceed 2 metres multiplied by the number of connected devices, up to a maximum of 20 metres. And no more th...

...money. • Computer cables can only be too short, but never too long. The same applies to networking cables. Sometimes it is just the last meter that is missing, but in many cases some kilometres are missing. A standard 10/100 or 10/100/1000 Cop...

...ratios • Within a CATx cable of a certain length, the individual pairs might have individual different lengths, caused by higher or lower twist ratios. • There are two common cable standards: • One with a 2 + 2 structure (two pairs of approximately...

...more. You can run fibre cable next to industrial equipment without worry. Fibre is also less susceptible to temperature fluctuations and can be submerged in water. • Security • Fibre doesn't radiate signals and is extremely difficult to tap. If it i...

...signals over CATx cable up to 100 metres (330 feet), and even farther with the addition of network switches. • Flexible topology with many options • Configure the Agility for point-to-point extension, multicasting, single-target sharing, and K...

...cabling is good, solid cable for 100-Mbps LANs. The Category 5 standard has been around since 1991, so it’s well established. You’ll find existing Category 5 installations everywhere. What can Category 5 cable do, and what can’t it do? • If you sti...

...of the most important cable measurements is Near-End Crosstalk (NEXT). It’s signal interference from one pair that adversely affects another pair on the same end. Crosstalk occurs between adjacent wire pairs (“pair-to-pair NEXT”). In addition, all...